After cutting for a period of time, the saw blade of the ceramic tile cutter will crack and chip. Then the saw blade must be replaced at this time. How do you replace the blade of the cutter for the novice ? What needs to be paid attention to? Let's take a look!

　　How to replace the blade of the tile cutter?

　　 1. Remove the saw blade. The cutting saw itself is marked with the direction of rotation of the saw blade. The thread of the compression nut used to fix the saw blade is opposite to the direction of rotation of the saw blade. Therefore, when the saw blade rotates, the bolt will be tightened along with the rotation. When removing and replacing the saw blade, first fix the saw blade with a wrench, and then turn the nut on the saw blade in the direction shown by the arrow of the cutting tool itself to remove the saw blade.

　　 2. Pay attention when installing the saw blade of the tile cutter. The direction of the arrow marked on the saw blade must be consistent with the direction of the arrow marked on the saw blade cover.

　　3. When disassembling parts, mark and record the parts in accordance with the order of disassembly.

　　 4. Replace the saw blade with a new one.

　　 5. Reset each part according to the reverse order and mark of the disassembled parts.

　　 6. Tighten the fixing nut.

　　 7. The test run is mainly to check whether the saw blade rotates smoothly. If the saw blade runs smoothly, the saw blade replacement is completed.

Some precautions when installing the blade of the tile cutter:

　　 1. Before use, you must carefully read the operating instructions of the cutting machine and the items recorded on the package shell.

　　 2. Select the type of saw blade according to the material to be cut, and check whether the saw blade has cracks, deformation, or tooth loss. If the saw blade is damaged, do not use it.

　　3. When using, be sure to install the protective cover of the saw blade shell of the cutting machine, and wear a mask or goggles.

　　 4. Before installing the saw blade, please check whether the main shaft of the cutting machine is jumping. When installing, fix the saw blade with flanges and nuts. After installation, check whether the center hole of the saw blade is firmly fixed on the flange of the table. If there is a gasket, cover the gasket. After purchase, gently push the saw blade by hand to confirm whether the rotation is off-center.

　　 5. After the alloy saw blade is installed, it needs to be rotated for one minute before it can be used. The cutting operation can only be carried out when the machine is in working condition.

　　6. In non-automatic cutting operation, the saw blade in normal operation must be lightly cut into the material, and excessive force is strictly prohibited. It is forbidden to reverse and stop the saw blade suddenly in the middle of the object to be cut, otherwise the saw teeth will fall off and the saw body will be deformed, which may cause danger.

　　 7. If you hear abnormal sound during use, see abnormal shaking or uneven cutting surface, please stop the operation, find out the cause of the abnormality, and replace the saw blade in time.

　　 8. After cutting, please wipe off the anti-rust oil in time to prevent the saw blade from rusting due to long periods of inactivity.

　　 9. Please hang the saw blade vertically on a dry knife holder, avoiding wet places. Do not lay the saw blade flat on the ground, otherwise it will easily cause the saw blade to deform. Multiple saw blades should not be stacked directly, and should be packaged at intervals to avoid collision of saw teeth.

　　 10. If the saw blade is not sharp, it needs to be sawed again. If the saw blade is not polished in time, it is easy to damage the original angle of the saw teeth, which will directly affect the cutting accuracy and shorten the service life of the saw blade.

　　The blades required for general cutters mainly include cutting blades, chamfering wheels, filleting wheels, slotting blades, diamond filleting wheels, and diamond chamfering wheels. Users can replace the blades according to their needs. The cutting styles are complete and there are many types.