Waterjet cutting machine is a kind of equipment that is widely used. With the continuous development of technology, the newly developed five-axis waterjet has gradually matured and been used by many manufacturers. The waterjet cutting machine will also encounter some problems during use, such as: frequent damage to the high-pressure water seal ring, causing the water jet high-pressure cutting water to leak, sometimes even causing the water tank to rupture, what should happen when the high-pressure cutting water is sprayed? What to do? The following editor will share solutions to these problems for you, let's take a look!

　　 One, high pressure water seal ring has a short life

　　 1. The gap between the seal ring and the high-pressure water plunger is too large. Solution: Remove the high-pressure water tank, replace all high-pressure water sealing rings, and carefully check the high-pressure water plunger. If the diameter is less than the specified value or the surface is too rough, replace the main plug.

　　 2. The high-pressure water plunger has scratches. Solution: Check the plunger and replace if necessary.

　　 3. The high-pressure water tank is severely worn. Solution: Check carefully for wear, especially the end. If the inner diameter is larger than the specified value, replace it. If the seal ring is recessed or worn, replace the high-pressure water cylinder.

　　 4. Polluted water. Solution: Check the water sample and check the filtration system.

　　 Two, The high-pressure water tank ruptured

　　 Metal fatigue. Solution: Replace the high-pressure water cylinder, because the high-pressure cylinder has a certain life span. According to the environment of use, the high-pressure cylinder must be replaced regularly. The main reason for the damage earlier than expected was scratches on the cylinder block. When replacing the high-pressure water tank, please replace all high-pressure water sealing rings, and record the maintenance and work interval time for future reference.

　　 When any of the above situations occurs, the machine should be stopped immediately, and the machine can be operated again after inspection and maintenance. If you want to know more about the waterjet cutting machine, you can also consult our online customer service.

       For more information click our official website:Foshan nanhai hongyun ceramic machinery company.If you are interested in this machine,please contact me in Whatsapp or email(whatsapp number:+86 152 7835 3800;email:hanistay@foxmail.com)