Compared with other ceramic tile processing equipment, ceramic tile edging machine has higher automation and more convenient operation. As long as you pay attention to the matters during operation, the service life of your machine will be longer.

   Before the start-up of the tile edging machine, it is necessary to check whether there are any problems in each part. After confirmation, the machine can be started for edge grinding operation. What should be paid attention to in the operation of the tile edging machine?

  With the continuous development of ceramic tile machinery, there are many types of ceramic tile edging machine series at present, and the operation methods of each equipment are different. The following describes the same operation mode of tile edging machine to introduce the precautions for its use.

   What are the precautions for the use of tile edging machine?

   1. Because the edge grinder is processed by circulating water in order to prevent dust splashing during the process of working, the dust shield of the motor should be in the sealed state when using tile grinding to prevent the sewage dust or ceramic tile debris from entering.

   2.In order to prevent the temperature of the grinding wheel from being too high during the processing of ceramic tiles, the ceramic tile edging machine often uses circulating water for cooling. When processing ceramic tiles, it is necessary to always pay attention to prevent circulating water from entering the main bearing shaft. If it is found to enter, it should be cleaned up immediately.

   3. When you turn on the motor button of the ceramic tile edging machine, you need to wait for one minute before processing the tiles. It should be noted that the motor will generate a lot of heat during processing. If the motor is overheated, stop working immediately and wait for the motor to cool down completely. It can be started again afterwards.

   4. During the loading process of the tile edger, the slow-in and slow-out must be strictly followed, and the feed should not be too slow.

   5. In order to prevent the machine from leaking when using the ceramic tile edging machine, a hemp ring should be added to the liner screw that fixes the ceramic tile edging machine.

   In addition to the above-mentioned major problems when operating the ceramic tile edging machine in normal operation, it is also necessary to strictly follow the equipment operating rules to operate. Since the water in the ceramic tile processing machine is very dangerous during the operation, it must be careful during the operation.