Fully automatic rock slab processing equipment is currently the most commonly used machinery for processing rock slabs. Generally, it will go through a series of training before operation. Because the training content is more, you may remember that it is not particularly complete at a time. Here is the full automatic science popularization for everyone.It is about how to operate rock slab processing equipment.

1. After the machine is installed, connect the cable connector between the console and the whole machine, and connect the external power supply of the console. The power supply is AC three-phase four-wire, and the voltage is 380V. Then check whether the rotating parts of the whole machine are flexible and whether the fasteners are loose. When the main power button is pressed, the indicators on the console panel are all bright. Then look at the direction of rotation of the host. Is it consistent with the direction marked with an arrow? Otherwise, the adjustment should be stopped immediately, and the rotation direction of other parts of the whole machine should be adjusted together with the main machine when leaving the factory. If the main machine rotates correctly, the other parts rotate correctly!

2. After all inspections are completed, the splint can be installed for cutting. When clamping the rock slab, a reliable clamping point should be selected to prevent false clamping or false clamping, so as to avoid damage to the blade and the plate due to the movement of the rock slab during the cutting process.

3. The machine adopts automatic feeding.The feeding speed is adjusted at a constant speed according to the size and hardness of the rock sample. After one cut, the pointer of the speed regulator must be reset to zero, and then the power supply must be turned off.

4. During the cutting process, strictly monitor the console and always pay attention to whether the cooling water 6 is sufficient to prevent insufficient cold cutting.

5. When the tool moves to the terminal, it is necessary to stop the operation of the host and coolant after the blade is completely out of work, and then open the closed port.

6. After use, turn off the switch, cut off the power, clean the residue on the table, wipe off the water stains on the blade and table, and add lubricating oil to the feeding trolley, cutter shaft and guide rail.

7. During the operation of the main engine, all parts of the human body shall not extend into the range of the mechanical stroke.

8. Pay attention to the operating status during use. If there is any abnormality, stop the machine immediately and notify the Material Safety Department for inspection and maintenance. Only after the maintenance is qualified, it can be used.

It is necessary to clean the rock slab processing equipment immediately after the work is finished, so as not to get too fast for a long time, and the next cleaning will be more difficult. The above is the content of the safe operation of the fully automatic rock slab processing equipment. I hope it will be helpful to you.

FOSHAN NANHAI HONGYUN CERAMIC MACHNERY CO.LTD

Tel: +86-18666532535 (Mr.Huang)

Email:hanistay@foxmail.com

Looking forward your message.